Want to fit a ZR bumper to your Rover 25, or replace an accident damaged bumper?

This how to guide shows step by step instructions on removing and replacing your MG ZR / Rover 25 rear bumper.

Rover 25 MG ZR rear bumper removed
This post may contain affiliate links. Please read my disclosure for more info.


Time to Complete - 20-30 minutes


Difficulty - 2/5


Tools and Parts Required

  • Phillips head screw driver
  • Ratchet
  • 10mm socket
  • Torque wrench



Disclaimer: Any information given in this guide is to be used at the readers own risk. I take no responsibility for injuries to the reader or damage to their vehicles. If this guide is followed correctly, no harm should occur to either the reader or the car.

Please read through the entirety of this guide prior to undertaking any work, and take due care.



How to Remove and Refit a Rover 25 / MG ZR Rear Bumper


Step 1

Please follow my guide to removing the rear lights before continuing with step 2.



Step 2

Once the rear lights are removed, you will see two bolts holding the top corner of the bumper on. Using the 10mm socket remove both of them.

10mm socket
Rover 25 MG ZR rear light removed



Step 3

Using the 10mm socket again, locate and remove the bolt in both wheel arches. It is at the top of the rear bumper, as shown below.

Rover 25 MG ZR rear bumper fixing

Step 4

Still with the 10mm socket, locate and remove the bolt underneath the middle of the rear bumper. It is next to the tow eye, as shown below.

Rover 25 MG ZR rear bumper fixing

Step 5

For this step it may be (definitely will be) easier to remove the rear wheels.

You will need to use the Phillips head screw driver to remove the larger inner screw from each rear bumper end cap.

Rover 25 MG ZR rear bumper end cap fixings



Step 6

Finally open the boot and remove the 5 screws in the top of the bumper. You will also need to remove the plugs that the screws go into. Once removed the bumper should come away. With the bumper removed your car shell should look like this.

Rover 25 MG ZR rear bumper removed

Step 7

To refit the bumper, just repeat steps 1 - 6 in reverse order.

Please note the torque wrench settings for the bumper to body bolts: 22Nm / 16ft lb.